1、用專門的清洗劑徹底清洗合力變速箱冷卻器和冷卻油管，確保無任何雜物，油道暢通無阻，安裝完畢后，檢查流量壓力，正常情況下變速箱的壓力至少要達到12KG以上。必要時更換水箱冷卻器油管；
1. Thoroughly clean the Heli transmission cooler and cooling oil pipe with special cleaning agent to ensure that there are no sundries and the oil passage is unblocked. After installation, check the flow pressure. Under normal conditions, the transmission pressure should be at least 12KG. Replace the water tank cooler oil pipe if necessary;
2. Shandong transmission maintenance personnel remind you to check whether the torque converter is installed in place;
3、檢查發動機和合力變速箱之間定位銷和各個螺絲是否安裝齊全；
3. Check whether the locating pins and screws between the engine and the resultant gearbox are completely installed;
4、檢查變扭器螺絲是否過長和安裝螺栓扭緊后機器是否緊密貼合；
4. Check whether the torque converter screws are too long and whether the machine fits tightly after the installation bolts are tightened;
5、檢查飛輪跳動量（參考值：在1.0mm以下）；
5. Check the flywheel runout (reference value: below 1.0mm);
6、檢查掛檔桿和油門拉線和真空管路是否調節好；
6. Check whether the shift lever, accelerator cable and vacuum pipeline are properly adjusted;
7、加注原廠規定的自動變速箱油（手動檔車型要另外加齒輪油），檢查油面高度，不可過多或過少；
7. Fill in the automatic transmission oil specified by the manufacturer (gear oil shall be added additionally for the model with manual gear), and check the oil level, which shall not be too much or too little;
8、檢查機腳膠是否損壞；
8. Check whether the foot glue is damaged;
9、確定各線插、搭鐵線完全裝好，傳動軸、半軸按規定裝配；
9. Make sure that all wire plugs and grounding wires are completely installed, and the transmission shaft and half shaft are assembled as required;
10、變速箱是車體中非常重要的系統，直接影響到行車的安全，建議一旦發現問題后應及時進行維修。
10. The gearbox is a very important system in the vehicle body, which directly affects the safety of driving. It is recommended to repair it in time once any problem is found.
What inspection is required after the transmission is repaired? The above is the relevant answer to the question. I hope it can help you. Please come to our website for more matters http://www.566605.com consulting service
