1、 Replace the transmission oil properly

動態性換油選用專用型的變速器清洗機械，在變速器運行的全過程中，將舊油充足循環系統，排污整潔后再添加新油，進而使換油率達到90%左右，能確保優良的換油實際效果，提議選用動態性換油。

Special transmission cleaning machine shall be selected for dynamic oil change. During the whole process of transmission operation, the old oil shall be fully circulated to the system, and new oil shall be added after sewage discharge, so as to make the oil change rate reach about 90%, which can ensure excellent actual effect of oil change. It is proposed to select dynamic oil change.

二、常常查驗自動變速箱專修油液位儀

2、 Often check the automatic transmission oil level gauge

發動機油在涼車情況下查驗，而查驗變速箱油一定將油加熱到50℃上下，再將擋位桿在各擋位滯留2秒左右后放置泊車擋，這時油尺正常油面應坐落于大與少線中間，如不足，應立即加上。

The engine oil shall be checked when the vehicle is cold, and the transmission oil shall be heated to above and below 50 ℃, and then the gear lever shall be held in each gear for about 2 seconds before placing the parking gear. At this time, the normal oil level of the dipstick shall be located between the large and small lines. If it is insufficient, it shall be added immediately.

三、按時拆換自動變速箱油

3、 Remove and replace the automatic transmission oil on time

濟南自動變速箱維修內控制度組織十分高精 密，相互配合空隙小，大多數自動變速箱換油周期時間一般為2年或4到6萬多公里。變速箱油應用時間長了之后會造成油污，增加各磨擦片和各構件的損壞，還會危害系統軟件汽壓，使驅動力傳送遭受危害，因而要把握好拆換自動變速箱油的周期時間。

Jinan automatic transmission maintenance internal control system organization is very high-precision, and the mutual cooperation gap is small. The oil change cycle time of most automatic transmissions is generally 2 years or more than 40000 to 60000 kilometers. After the transmission oil is applied for a long time, it will cause oil contamination, increase the damage of friction plates and components, endanger the steam pressure of system software, and endanger the transmission of driving force. Therefore, it is necessary to grasp the cycle time of removing and replacing automatic transmission oil.