隨著消費者對汽車的了解，變速箱作為動力系統的一部分，在消費者購買汽車時自然成為一個重要的考慮因素。變速箱維修每個檔位都有不同傳動比，相當于小齒輪與大齒輪的嚙合能產生不同的轉速，低速行駛時用低傳動比（3檔及以下），大軸轉速低于發動機轉速，可獲得更大的驅動力，高速時用高傳動比（4檔及以上），大軸轉速高于發動機轉速，降低牽引力獲得更高速度，切檔位即選擇不同尺寸的齒輪和大軸的齒輪嚙合。
With the consumers' understanding of the car, gearbox, as a part of the power system, naturally becomes an important consideration when consumers buy a car. Gearbox maintenance has different transmission ratios for each gear position, which is equivalent to the simultaneous interpreting of the meshing between the pinion and the big gear. The low transmission ratio (3 gears and below) can be obtained at low speed, and the greater shaft speed is lower than the engine speed. The greater driving force can be obtained. When the speed is high, the high transmission ratio (4 gears and above), the shaft speed is higher than the engine speed, and the traction force can be reduced more quickly. Gear shifting means that gears of different sizes are selected to mesh with gears of main shaft.
變速箱維修起步、怠速停車、低速或高速行駛、加速、減速、爬坡和倒車等，這就要求汽車的驅動力和車速能在相當大的范圍內變化，而目前廣泛采用的活塞式發動機的輸出轉矩和轉速變化范圍較小。為了適應經常變化的行駛條件，同時使發動機在有利的工況下(功率較高、油耗較低)工作，在傳動系統中設置了變速器。
Transmission maintenance start, idle parking, low or high speed driving, acceleration, deceleration, climbing and reversing, etc., which requires the driving force and speed of the car to change in a considerable range, while the widely used piston engine has a smaller range of output torque and speed. In order to adapt to the frequently changing driving conditions and make the engine work under favorable working conditions (high power and low fuel consumption), a transmission is set up in the transmission system.
眾所周知，自動變速器分為自動變速器和手動變速器，自動變速器以其操作方便、操作方便等優點在市場上占有很高的市場份額。然而，自動變速器的維護難度大，維護成本高。
As we all know, automatic transmission is divided into automatic transmission and manual transmission. Automatic transmission occupies a high market share in the market with its advantages of convenient operation and easy operation. However, the maintenance of automatic transmission is difficult and costly.
自動變速箱配有大量電磁閥，以及非常復雜的機械部件。在維修過程中，維護過程中存在輕微疏忽，這可能導致自動變速器報廢。因此，應去的地方自動修理變速箱。包頭自動變速箱養護只想說，如果自動變速器損壞，它的性能如何？
The automatic transmission is equipped with a large number of solenoid valves and very complex mechanical components. In the process of maintenance, slight negligence in the maintenance process may cause the automatic transmission to be scrapped. Therefore, should go to professional place automatic repair gearbox. Baotou automatic transmission maintenance just want to say, if the automatic transmission damage, its performance?
1。駕駛時的震驚感。
1。 Driving shock.
2.進入/轉移影響，甚至停滯。
2. Impact of entry / transfer, even stagnation.
自動變速箱維修
Automatic transmission maintenance
3.車輛打滑，無法運行。開始無法啟動。
3. The vehicle skids and cannot run. Start failed to start.
4.有異常的噪音（1.駕駛時噪音異常，踩油門的聲音變大;2.駕駛內部發出沙沙聲，踩油門后沒有聲音，有聲音轉移等）。
4. There is abnormal noise (1. The noise is abnormal when driving, and the sound of stepping on the accelerator becomes louder; 2. There is a rustling sound inside the driver, there is no sound after stepping on the accelerator, there is a sound transfer, etc.).
自動變速器是整個汽車的核心部件，因此很有必要做好它的維修工作。自動變速器維修人員說，許多車主在正常駕駛過程中容易犯一些低級錯誤，隨著時間的推移，這會對變速箱造成致命的損壞。因此，只要做好汽車自動變速器的保養工作，就可以延長汽車的使用壽命，使行駛里程達到理想狀態！
Automatic transmission is the core part of the whole car, so it is necessary to do its maintenance work well. Automatic transmission maintenance personnel said that many car owners are prone to make some low-level mistakes in the normal driving process, which will cause fatal damage to the transmission over time. Therefore, as long as we do a good job in the maintenance of the automatic transmission, we can extend the service life of the car and make the driving mileage reach the ideal state!
